Dreame Robot vacuum Dreame D9 Network connection fails
What this problem usually means
The D9 cannot connect to the network / Mi Home app.
Likely causes
- A 5G Wi-Fi network was used (D9 only supports 2.4G Wi-Fi)
- Robot and phone are too far from the router / weak Wi-Fi signal
- App location permission is not enabled
How to fix it — step by step
- Connect using a 2.4G Wi-Fi network; 5G Wi-Fi is not supported
- Make sure the robot and your phone are close to the router with strong Wi-Fi signals
- When connecting to the D9's hotspot, return to the Mi Home app to wait for the connection result after hearing the voice report
- Enable the location permission of the app before network connection
- If the network still fails, restart the robot (host) and the router
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame D9 problems
- Side brush or main brush is entangled during cleaning
- Cleaning performance fades / debris is missed on the floor
- D9 fails to charge
- D9 fails to power on
- D9 fails to reposition itself
- D9 fails to resume cleaning after recharging itself
- D9 fails to return to the dock
- D9 fails to squirt water, or only a little water comes out during mopping
- D9 is trapped during cleaning
- D9 keeps trying to connect after returning to the dock
- Device error (generic error state)