Dreame Robot vacuum Dreame D9 D9 fails to squirt water, or only a little water comes out during mopping
What this problem usually means
Little or no water is dispensed while mopping.
Likely causes
- Water level in the water tank is low
- The mop is not installed properly
- The mop is dirty
- The mop pad was not wetted before mopping
How to fix it — step by step
- Check the current water level in the water tank and refill if needed
- Install the mop properly according to the instructions
- Clean the mop in time
- Wet the mop pad before mopping for a better mopping experience → Shop the mop pad at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Mop pad.
Parts that commonly fix it
- Mop pad - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame D9 problems
- D9 is trapped during cleaning
- D9 keeps trying to connect after returning to the dock
- Device error (generic error state)
- Network connection fails
- Side brush or main brush is entangled during cleaning
- Cleaning performance fades / debris is missed on the floor
- D9 fails to charge
- D9 fails to power on
- D9 fails to reposition itself
- D9 fails to resume cleaning after recharging itself
- D9 fails to return to the dock