Buick SUV Envista Wet timing belt degradation and engine failure
What this problem usually means
The Envista's only engine, the 1.2L (LIH) E-Turbo three-cylinder, runs a wet timing belt in oil. Go-Parts' engine guide for the Trax/Envista 1.2L warns that belt material degrades and contaminates the oil, potentially clogging oil passages and the pickup, and documents owner reports of sudden power loss, knocking, stalling and even connecting rod failure.
Likely causes
- Wet timing belt shedding material into the oil → Shop the wet timing belt at Amazon
- Oil pickup/oil passage blockage from belt debris
- Oil starvation leading to bearing/rod failure
How to fix it — step by step
- Use only the specified oil and keep intervals short - the belt lives in the oil
- Treat an oil pressure light or sudden knock as a stop-and-tow event
- Ask about belt inspection/replacement well before the nominal 150,000-mile interval if the car does short trips
- If debris is found, the oil system must be cleaned and internal engine damage assessed by a shop
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the wet timing belt.
Shop the wet timing belt at Amazon
Also tied to this fault: oil pickup screen - Shop at Amazon
Parts that commonly fix it
- wet timing belt - Shop at Amazon
- oil pickup screen - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.