Buick SUV Envista Engine knock after auto stop/start
What this problem usually means
Envista (and Trax) owners have reported a persistent engine knock, especially after an auto stop/start event. Go-Parts' 1.2L guide links the knock-after-restart pattern to a spark timing issue that GM addressed with a recall software update.
Likely causes
- Incorrect ignition timing calibration after auto-stop restart
How to fix it — step by step
- Note whether the knock follows an auto stop/start restart specifically
- Check for open recalls/software campaigns on your VIN at a dealer
- Have the engine control software updated to the latest calibration
- If knocking persists after the update, have the engine inspected for mechanical damage before driving hard
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.