Buick SUV Envision (First generation, 2016–2020) Engine damage from low-speed pre-ignition
What this problem usually means
The first-generation Envision's 2.0L turbo (LTG) can suffer low-speed pre-ignition (LSPI) - combustion firing before the spark at low rpm and high load - which can crack piston ring lands and destroy the engine. The what-breaks guide attributes the risk to a tight factory top ring end-gap on early years and stresses LSPI-resistant dexos oil and premium fuel as the prevention.
Likely causes
- Low-speed pre-ignition (LSPI) at low rpm/high load
- Non-LSPI-resistant engine oil
- Regular fuel under high boost load
How to fix it — step by step
- Treat a sharp metallic knock under low-rpm load as a stop-and-check symptom
- Verify the oil used meets GM's LSPI-resistant dexos specification
- Use premium fuel as the guide recommends for this engine
- Severe LSPI damage means engine repair or replacement - a shop must assess piston/ring damage → Shop the piston and ring set at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the piston and ring set.
Parts that commonly fix it
- piston and ring set - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.
Related Buick SUV Envision (First generation, 2016–2020) problems
See all Buick Envision (First generation, 2016–2020) codes & guides →