BMW Sedan 3 Series Engine stalls when stopping

What this problem usually means

The torque converter clutch can stick 'on' after extended freeway driving, causing the engine to stall when coming to a stop. The engine usually restarts in Park and stalls again when put into gear; after the engine and transmission cool for about twenty minutes it operates normally. The repair requires replacement of the torque converter clutch solenoid, transmission filter and transmission fluid.

Likely causes

  1. Torque converter clutch sticking on after extended freeway driving
  2. Torque converter clutch solenoid fault

How to fix it — step by step

  1. Note whether stalling only happens right after a long freeway run and clears after a cool-down - that pattern is diagnostic
  2. Scan the transmission for fault codes
  3. Have the torque converter clutch solenoid, transmission filter and fluid replaced → Shop the torque converter clutch solenoid at Amazon → Shop the transmission filter at Amazon
  4. Road-test including a freeway run and stop to confirm

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related BMW Sedan 3 Series problems

See all BMW 3 Series codes & guides →