Audi SUV Q3 (F3, 2019–2025) Steering rack bolt corrosion

What this problem usually means

One of the bolts holding the steering rack to the subframe on 2019-2021 Q3s (and some VW Tiguan and Atlas) can corrode and break, which can crack the steering rack housing and cause a loss of steering control. This is NHTSA recall 26V590 (208,724 vehicles campaign-wide); dealers replace the right-side mounting bolt, and owner letters were due in November 2026. Symptoms can include a clunk from the front end over bumps and steering that feels loose or off-center.

Likely causes

  1. Steering rack mounting bolt corroding and breaking → Shop the steering rack mounting bolt at Amazon
  2. Steering rack housing cracking as a consequence → Shop the steering rack at Amazon

How to fix it — step by step

  1. Note any front-end clunk over bumps or loose/off-center steering
  2. Run your VIN through NHTSA's recall lookup and confirm whether the 26V590 remedy shows as complete
  3. Ask the dealer whether the replacement bolt is installed or parts are still pending
  4. Have the dealer replace the mounting bolt - and the rack if its housing is cracked - under the recall

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Audi SUV Q3 (F3, 2019–2025) problems

See all Audi Q3 (F3, 2019–2025) codes & guides →