Audi Sedan A6 (C7, 2012–2018) Supercharger Rattle

What this problem usually means

The C7 A6 3.0T's Roots-type supercharger is driven off the front of the engine through a coupler that wears over time, per the CarScout C7 guide: early signs are a rattling or clacking noise at idle, progressing to a whine and then grinding. If the bearing seizes it can shred the accessory drive belt, stopping the water pump and alternator at the same time. Caught at the clack stage, coupler replacement is roughly $400-$800.

Likely causes

  1. Supercharger coupler wear
  2. Supercharger bearing wear progressing from rattle to grinding
  3. Accessory drive belt failure as a consequence of a seized supercharger → Shop the accessory drive belt at Amazon
  4. Timing chain rattle at the rear of the engine, a separate noise that must be distinguished

How to fix it — step by step

  1. Locate the noise: supercharger coupler rattle is at the front of the engine, timing chain rattle at the rear → Shop the supercharger coupler at Amazon
  2. Listen at idle when cold; a clacking that changes with engine speed supports the coupler
  3. Replace the coupler early rather than waiting for the whine or grinding stage
  4. Inspect the accessory belt and pulleys at the same time, since a seizure damages them

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Audi Sedan A6 (C7, 2012–2018) problems

See all Audi A6 (C7, 2012–2018) codes & guides →