Audi Sedan A6 (C7, 2012–2018) Coolant Leak
What this problem usually means
The water pump and thermostat housing on the C7 A6 3.0T are plastic and both develop slow leaks from about 80,000 miles onward as the plastic degrades from heat cycling, per the CarScout C7 guide. Symptoms include a sweet smell from the engine bay, minor coolant staining near the front of the engine and occasional low-coolant warnings, and the full water pump and thermostat assembly typically runs $900-$1,500 fitted.
Likely causes
- Plastic water pump housing degrading with heat cycling
- Plastic thermostat housing leaking
- Water pump seal failure weeping coolant
- Low coolant level causing overheating if the leak is ignored
How to fix it — step by step
- Top up only with the correct specification coolant and start a level log; a steady fall confirms a leak
- Look for dried coolant staining at the front of the engine and smell for the sweet coolant odour after a drive
- Pressure-test the cooling system to confirm the pump and housing as the source before replacing parts
- Replace the water pump and thermostat housing together; they are adjacent plastic parts of the same age → Shop the thermostat housing at Amazon → Shop the water pump at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water pump.
Also tied to this fault: thermostat housing - Shop at Amazon
Parts that commonly fix it
- water pump - Shop at Amazon
- thermostat housing - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.