Aiper Pool cleaner Scuba N1 Red light flashing
What this problem usually means
The red light keeps flashing and the device is not working: a fault — most often something jammed in the running gear or the drainage (pump) motor, and if cleaning does not clear it, Aiper says the logic control circuit may have failed.
Likely causes
- Debris in the transmission gears or wheels
- Debris blocking the drainage motor blades
- Something blocking the brush
- Logic control circuit failure (if the fault persists after cleaning)
How to fix it — step by step
- Turn off the device and clean the transmission gears, wheels, and drainage motor blades, then restart and try again
- Turn off the device and check whether anything is blocking the brush; clear it
- If the problem persists after the above checks, the logic control circuit may have failed — contact Aiper support with the model, serial number, symptoms, and a photo or short video
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.