Aiper Pool cleaner Scuba N1 App displays "High Battery Temperature"
What this problem usually means
The Aiper app shows a "High Battery Temperature" warning and the device will not run or charge normally — the battery pack is too hot.
Likely causes
- Battery overheated from sun exposure or hot ambient conditions
- Operating or charging outside the recommended ambient temperature range (50-95°F / 10-35°C)
How to fix it — step by step
- Remove the device from the pool and place it in a shaded area away from direct sunlight
- Allow it to cool for 1-2 hours before attempting to use it again
- If the device continues to show "High Battery Temperature" while operating within the recommended ambient temperature range and cannot be charged, contact Aiper support
- If excessive heat or casing swelling is observed, stop using the device immediately and contact Aiper
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.