Winix Air purifier Zero S (AZSU350-JWE) Particle Sensor Cleaning
What this problem usually means
Sensor-cleaning guide from the manual's Cleaning Care section (Smart Detector / Particle Sensor care): for optimal performance the particle sensor lens and intake area should be cleaned regularly - the manual's maintenance schedule covers cleaning the sensor with a damp cotton swab, using only water.
Likely causes
- Dust and particles build up on the particle sensor lens and intake area
- Sensor performance degrades if the lens and intake are not cleaned
How to fix it — step by step
- Unplug the unit before cleaning and wait until it has cooled down
- Use a damp cotton swab to wipe the lens and intake area of the Particle Sensor - to clean the sensor area, use only water; do not use volatile substances such as alcohol or acetone
- Wipe away any remaining moisture with a dry cotton swab
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.