Winix Air purifier C535 Check Filter

What this problem usually means

Check Filter Indicator: the LED light indicates when it is time to change the filter - on this model, when the Check Filter indicator LED is on, it is time to replace the True HEPA Filter, which lasts approximately 12 months. The Carbon Filter Sheet is replaced every 3 months and the Pre-Filter is permanent, cleaned once every 14 days.

Likely causes

  1. True HEPA Filter has reached the end of its approximately 12-month life
  2. Filters are heavily soiled, have a bad odor, or fan strength is significantly weakened - the manual says to replace filters in these cases even if the Check Filter indicator has not yet turned on

How to fix it — step by step

  1. Turn the unit power off and remove the front panel by grasping its upper edge and gently pulling forward
  2. Press the Pre-Filter tabs near the top of the filter, release and remove the Pre-Filter, then pull out the Carbon Filter and True HEPA Filter → Shop the true hepa filter at Amazon
  3. Remove the new filters from their protective plastic wrap - operating the unit without removing the wrap may cause abnormal noise, deformation or fire from overheating
  4. Install the True HEPA Filter first, then the Carbon Filter, then insert the Pre-Filter, and put the front panel back on
  5. Turn the power on to the unit and use a thin object such as a paper clip to press the RESET switch for 5 seconds

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Winix Air purifier C535 problems

See all Winix C535 codes & guides →