Whirlpool Dryer Cabrio Steam and 2015 Cabrio F4 E1 Error Code
What the F4 E1 code means
Heating fault: on Cabrio steam models this is a heating element failure, and on 2015 Cabrio models a heater relay failure.
Likely causes
- Failed heating element
- Heater relay fault on the electronic control board → Shop the electronic control board at RepairClinic
- Loose harness between the element/relays and the control
How to fix it — step by step
- Unplug the dryer (or switch off both breakers) for 1 minute and restore power
- Check both breakers have not tripped and run a Timed Dry heated cycle
- If there is still no heat and the code returns, call for service - do not open the cabinet to test the element or relays yourself → Shop the heating element at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the heating element.
Shop the heating element at RepairClinic or Amazon
Also tied to this fault: electronic control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F4 E1 code
- heating element - Shop at RepairClinic or Amazon
- electronic control board - Shop at RepairClinic or Amazon
Before you buy: check the heating element first
Test: Unplug the dryer, pull one spade connector off the element, and measure across the two element terminals; then probe one terminal and the metal element casing.
A good one reads: About 9–10 Ω across the terminals for a good element (iFixit Whirlpool dryer no-heat guide). No reading or a wildly higher reading means the element has failed; any continuity from a terminal to the casing means the element is grounded and must be replaced.
Look for: Inspect the element's wire connectors for burn marks or melted insulation, and don't reuse heat-damaged terminals (iFixit).
Test values from ifixit.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Whirlpool Dryer Cabrio Steam and 2015 Cabrio error codes
See all Whirlpool Cabrio Steam and 2015 Cabrio codes & guides →