Volvo Wagon V60 Knocking noise over bumps
What this problem usually means
The V60's P3 chassis shares the S60 II front-end weaknesses: knocking top mounts and worn tie rods. The test-drive tells are knocking on turn-in and a clacking front axle over expansion joints.
Likely causes
- Worn front strut top mounts → Shop the strut top mounts at Amazon
- Worn tie rods
How to fix it — step by step
- Drive over expansion joints and turn at low speed, listening for clacking or knocking from the front axle
- Have the top mounts and tie rods inspected for play on a lift → Shop the tie rods at Amazon
- Rule out worn anti-roll bar links, which produce a similar clack
- Replace the worn components
- Have a wheel alignment done after tie rod or mount replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the strut top mounts.
Shop the strut top mounts at Amazon
Also tied to this fault: tie rods - Shop at Amazon
Parts that commonly fix it
- strut top mounts - Shop at Amazon
- tie rods - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.