Vizio TV Lines on Screen
What this problem usually means
Horizontal or vertical lines, distortion, or other picture defects appear on the screen. Vizio's official display guide uses the TV's own menu/Home screen as the dividing test: if lines also appear in the menu, the fault is in the TV display or internal hardware; if the menu looks normal, the fault is the connected device, input, cable, app, or source. Lines on every input and in the menu that survive a power cycle and factory reset, or any lines after physical screen damage, are a service case — typically T-Con, panel connections, or the panel itself.
Likely causes
- Loose, damaged, or faulty HDMI/video cable or wrong input connection
- Faulty connected device (cable box, console, Blu-ray player, streamer) or a single bad input
- Picture settings or picture-processing features affecting the image
- Temporary software/display glitch cleared by a power cycle or Soft Power Cycle
- Physical screen damage — cracks, impact marks, or dark spots
- Internal display hardware failure (T-Con board, panel ribbons, or LCD panel) → Shop the t-con board at RepairClinic
How to fix it — step by step
- Power cycle: turn the TV off, unplug it, hold the physical power button for 5 seconds, plug it back in, turn it on, and check the picture — or use Menu/Gear > System > Reset & Admin > Soft Power Cycle if available.
- Run the menu test: open the TV menu or Home screen — lines there point to the TV/display hardware; a clean menu points to the connected device, cable, app, or source.
- Check connections: turn off TV and device, disconnect and firmly reconnect the HDMI/video cable at both ends to the correct input, then try a different cable, a different HDMI input, a different device, and connecting directly to the TV instead of through a receiver or switch. → Shop the hdmi cable at RepairClinic
- Test other sources: open a built-in streaming app, watch live TV if available, and switch inputs — if only one input/device shows lines, that device, cable, or source is the cause.
- Adjust picture settings: Menu/Gear > Picture, try a different Picture Mode (Standard, Calibrated, or Movie), use Reset Picture Mode if available, and toggle motion enhancement/noise reduction for content-specific issues.
- Inspect the screen for cracks, impact marks, or dark spots, and do not press or tap the screen — physical damage is not fixed by settings or cables.
- Factory reset if it persists: Menu/Gear > System > Reset & Admin > Reset TV to Factory Defaults (may be under Admin & Privacy) — this erases settings, apps, accounts, and network info.
- Request service if lines appear in the menu/Home screen, on every input and app, after power cycling and a factory reset, or if the screen is physically damaged or the picture is partially missing or worsening.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the T-Con board.
Shop the T-Con board at RepairClinic or Amazon
Also tied to this fault: main board - Shop at RepairClinic or Amazon; LCD panel - Shop at RepairClinic or Amazon; HDMI cable - Shop at RepairClinic or Amazon
Parts that commonly fix it
- T-Con board - Shop at RepairClinic or Amazon
- main board - Shop at RepairClinic or Amazon
- LCD panel - Shop at RepairClinic or Amazon
- HDMI cable - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.