Trane Furnace S-series seven-segment display — two-stage S9X2/S8X2 E3.4 Error Code

What the E3.4 code means

On two-stage Trane S-series furnaces with a seven-segment display (S9X2, S8X2), code E3.4 means the second-stage pressure switch is open — second-stage draft was not proved. It does not apply to single-stage S9X1/S9B1/S8X1 models.

Likely causes

  1. Blocked vent or intake at high fire
  2. Clogged condensate drain
  3. Weak inducer at second stage
  4. Failed second-stage pressure switch

How to fix it — step by step

  1. Clear the outdoor vent and intake terminations
  2. Check the condensate drain for clogs or freezing
  3. Reset power once and observe whether the fault occurs only on high heat demand
  4. Call a technician to test the second-stage pressure switch and inducer → Shop the pressure switch at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E3.4 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace S-series seven-segment display — two-stage S9X2/S8X2 error codes

See all Trane S-series seven-segment display — two-stage S9X2/S8X2 codes & guides →