Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1 E09 Error Code
What the E09 code means
On Trane S9X1, S9X2 and S9B1 furnaces (not listed for S8X1/S8X2), code E09 means an open inducer limit switch or condensate pressure switch.
Likely causes
- Overheated inducer motor tripping its limit → Shop the inducer motor at RepairClinic
- Blocked condensate drain raising the condensate switch
- Failed inducer limit or condensate switch
How to fix it — step by step
- Check the condensate drain hose and trap for clogs or freezing and clear what you can see
- Check outdoor vent terminations for blockages
- Let the furnace cool, then reset power once
- If E09 returns, call a technician to test the inducer and switches
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the inducer motor.
Shop the inducer motor at RepairClinic or Amazon
Also tied to this fault: condensate pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the E09 code
- inducer motor - Shop at RepairClinic or Amazon
- condensate pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace S-series seven-segment display — S9X1/S9X2/S9B1 error codes
See all Trane S-series seven-segment display — S9X1/S9X2/S9B1 codes & guides →