Trane Furnace S-series seven-segment display — S8V2 E4.2 Error Code
What the E4.2 code means
On Trane S8V2 furnaces only, code E4.2 means the roll-out limit switch is open — flame has rolled out of the burner compartment or the switch has failed. Other S-series models report this under E04.
Likely causes
- Blocked or cracked heat exchanger causing rollout
- Blocked venting
- Failed rollout switch
How to fix it — step by step
- Turn the furnace off and do not reset the rollout switch yourself → Shop the rollout switch at RepairClinic
- Do not keep trying to run the furnace
- Call a technician to inspect the heat exchanger and venting before any reset
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the rollout switch.
Parts that commonly fix the E4.2 code
- rollout switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace S-series seven-segment display — S8V2 error codes
See all Trane S-series seven-segment display — S8V2 codes & guides →