Toyota Truck Tacoma Won't crank due to bad starter
What this problem usually means
When a Tacoma's engine will not crank over, a bad starter is a common culprit, reported on the 1995-1998, 2001, 2005-2006 and 2008 model years at roughly 100,000 to 125,000 miles. Some owners fixed a similar problem by replacing the starter solenoid contacts, while others replaced the starter itself.
Likely causes
- failed starter motor
- worn starter solenoid contacts
How to fix it — step by step
- Turn the key and listen: a click with bright dash lights points to the starter circuit, dim lights to the battery
- Clean and tighten the battery terminals and have the battery load-tested
- Have power at the starter checked while the key is turned
- Replace the solenoid contacts or the starter motor if power arrives but the starter does not turn → Shop the starter solenoid contacts at Amazon → Shop the starter motor at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the starter motor.
Shop the starter motor at Amazon
Also tied to this fault: starter solenoid contacts - Shop at Amazon
Parts that commonly fix it
- starter motor - Shop at Amazon
- starter solenoid contacts - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.