Tesla Sedan Model S (2012–2020) No cabin heat

What this problem usually means

On pre-refresh Model S cars, a cabin that blows only cold air while the blower runs normally usually means the PTC heater has failed. After years of power cycles the heater's electronics can short out, and the failure often takes the roughly 40A high-voltage fuse with it, so replacing the heater alone may not restore heat if the fuse went too.

Likely causes

  1. Shorted PTC heater element or electronics → Shop the ptc heater at Amazon
  2. Blown high-voltage heater fuse (a common companion failure)
  3. Climate control or cabin temperature sensor fault (rule out before parts)

How to fix it — step by step

  1. Confirm the pattern: the blower works on all speeds but the air stays cold whatever temperature is set
  2. Install any pending software updates and try a reboot; if heat is still absent, it is hardware
  3. Do not keep replacing the fuse if it blows again; a shorted heater will take the new one with it
  4. Heater and fuse replacement is high-voltage work, and on most Model S cars reaching the fuse means lowering the battery pack, so this is Tesla or EV-specialist territory → Shop the high-voltage fuse at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Tesla manual is on Tesla's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Tesla Sedan Model S (2012–2020) problems

See all Tesla Model S (2012–2020) codes & guides →