Shark Air purifier HC500 Series FILTER LIFE illuminates and flashes
What this problem usually means
FILTER LIFE illuminates and flashes when the filter life reaches 0% remaining - it is time to install a new filter. The filters are engineered to last 6-12 months.
Likely causes
- Filter life counter has reached 0%
- NanoSeal Base Filter with True HEPA is at the end of its 6-12 month service life
How to fix it — step by step
- Turn the unit off and unplug it.
- Remove the filter cover from the back of the unit using the handle and pull the filter door towards you.
- Pull the old filter out by the removal tabs and discard it.
- Remove all packaging from the new filter.
- Insert the new filter and replace the cover: fit the bottom tabs into the slots and press the top, then the sides, until it clicks into place.
- Plug the unit in and turn it on. Calibration begins automatically.
- Press and hold the Info button for 3 seconds to reset the filter life percentage. A beep confirms the reset to 100%.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Shark NanoSeal Base Filter with True HEPA (HE2FKBAS / HE2FKBASMB / HE2FKPET).
Shop the Shark NanoSeal Base Filter with True HEPA (HE2FKBAS / HE2FKBASMB / HE2FKPET) at Amazon
Parts that commonly fix it
- Shark NanoSeal Base Filter with True HEPA (HE2FKBAS / HE2FKBASMB / HE2FKPET) - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.