Samsung TV Stuck on Logo / Boot Loop

What this problem usually means

The TV shows the Samsung logo then restarts, or never gets past the logo into Smart Hub/Tizen. This is usually corrupted firmware or Smart Hub data after an interrupted update or power loss, and a loop that survives a full power drain and a factory reset points to hardware, most often the power supply board or main board.

Likely causes

  1. Corrupted Tizen firmware after an interrupted software update
  2. Corrupted Smart Hub cache / app data
  3. Failing power supply board dropping voltage during boot → Shop the power supply board at RepairClinic
  4. Failed main board / flash storage

How to fix it — step by step

  1. Unplug the TV for 60 seconds and hold the TV's physical power button for 30 seconds to fully discharge it, then plug back in
  2. Disconnect all HDMI and USB devices and try booting with power only
  3. If the menu is reachable, update the software (Settings > Support > Software Update) and reset Smart Hub (Settings > Support > Device Care > Self Diagnosis > Reset Smart Hub, PIN 0000 by default)
  4. If still looping, factory reset (Settings > General & Privacy > Reset) if the menu can be reached
  5. A loop that survives power drain and reset is hardware - book service for power board / main board diagnosis → Shop the main board at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Samsung TV problems

See all Samsung TV codes & guides →