Samsung Robot vacuum Jet Bot The LiDAR sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.

What this problem usually means

Voice guide: there is a problem with the LiDAR sensor.

Likely causes

  1. LiDAR sensor problem

How to fix it — step by step

  1. Turn the power off, then on again
  2. If the notice remains, contact Samsung Customer Service

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Samsung Robot vacuum Jet Bot problems

See all Samsung Jet Bot codes & guides →