Samsung Robot vacuum Jet Bot Can't move in this no-go zone. Please move me somewhere else.
What this problem usually means
Voice guide: location recognition shows the Jet Bot is placed within a No-go Zone.
Likely causes
- Robot is inside a No-go Zone set in the app
How to fix it — step by step
- Check the No-go Zones in the SmartThings app
- Move the Jet Bot out of the No-go Zone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Samsung Robot vacuum Jet Bot problems
- Can't see anything. Please clean the front with a soft cloth.
- It's difficult to move. Please move me somewhere else.
- Please check the left wheel to see if there's something stuck in it.
- Please check the right wheel to see if there's something stuck in it.
- Please insert the bin so cleaning can start.
- Please remove the brush and take out whatever's stuck in there.
- Something's stuck in the side brush. Please remove it.
- Something's wrong with the cliff sensor. Please clean the 4 small black windows underneath with a soft cloth.
- Something's wrong with the front bump sensors. Please open the cover and check. The bumper might be jammed, or there might be something stuck in there.
- Something's wrong with the LiDAR bump sensor. The LiDAR cap might be jammed, or there might be something stuck in there.
- Something's wrong with the main system. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The LiDAR sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.