Samsung Robot vacuum Jet Bot AI+ Something's wrong with the LiDAR bump sensor. The LiDAR cap might be jammed, or there might be something stuck in there.

What this problem usually means

Voice guide: the LiDAR bump sensor needs to be checked.

Likely causes

  1. LiDAR cap jammed
  2. Foreign matter stuck between the LiDAR sensor and the main body

How to fix it — step by step

  1. Turn off the power switch and turn it back on
  2. Check for foreign matter between the LiDAR sensor and the main body and remove it if present

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Samsung Robot vacuum Jet Bot AI+ problems

See all Samsung Jet Bot AI+ codes & guides →