Roborock Robot vacuum S7, S7+, S7 MaxV Error 28
What this problem usually means
Robot on carpet. Move the robot to the floor and retry. S7-series only (verified in the official S7 and S7 MaxV manuals). The robot was started on carpet when it needed to start on the floor, for example for a mopping run.
Likely causes
- Robot placed and started on carpet or a thick rug
- Carpet sensor reading carpet at the start position
How to fix it — step by step
- Pick the robot up off the carpet
- Place it on hard floor
- Retry cleaning / mopping from the floor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.