Roborock Robot vacuum S6 MaxV, Q5, Q7 Max, S7, S7 MaxV Error 23

What this problem usually means

Could not return to dock. Clean the dock location beacon and retry (Q5/Q7 Max and S7/S7 MaxV manuals; the S6 MaxV manual words the same code 'dock location beacon lost - clean and retry', the beacon being blocked by dirt). The robot could not find or reach its dock. Do not confuse this with Error 23 on E-series and earlier S-series models, where the same number is worded as clearing the dock charger's signal area (see the other Error 23 entry).

Likely causes

  1. Dock location beacon dirty or blocked by dirt
  2. Dock unplugged, moved, or surrounded by clutter
  3. Robot started far from the dock with obstacles in the way

How to fix it — step by step

  1. Check the dock is plugged in and powered
  2. Clean the dock location beacon
  3. Clear clutter and keep clear space in front of and beside the dock
  4. Place the robot near the dock and send it to dock again

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Roborock Robot vacuum S6 MaxV, Q5, Q7 Max, S7, S7 MaxV problems

See all Roborock S6 MaxV, Q5, Q7 Max, S7, S7 MaxV codes & guides →