Roborock Robot vacuum S4, S4 Max, S5 Max, S6, S6 Pure, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV Error 1

What this problem usually means

LiDAR turret or laser blocked (LDS unit jammed). The laser distance sensor on top of the robot cannot spin or scan freely, so the robot cannot navigate. This is a LiDAR-model error: the E3 manual states explicitly that Error 1 is a code for other models and is not applicable to the E series, whose robots navigate without a LiDAR turret.

Likely causes

  1. Object resting on or jammed under the LiDAR turret
  2. Hair or debris caught around the laser head
  3. Robot wedged under low furniture pressing on the turret

How to fix it — step by step

  1. Remove anything resting on or around the LiDAR turret
  2. Gently rotate the laser head by hand to check it turns freely and clear any debris
  3. Wipe the laser sensor windows clean
  4. Move the robot to an open area and restart cleaning

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Roborock Robot vacuum S4, S4 Max, S5 Max, S6, S6 Pure, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV problems

See all Roborock S4, S4 Max, S5 Max, S6, S6 Pure, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV codes & guides →