RAM Truck 2500 (DJ, 2014–2026) Cold-start ticking noise

What this problem usually means

The other 6.4L HEMI tick on Ram 2500s is an exhaust leak: heat cycles warp the manifold and snap its bolts, so a lighter ticking or puffing is loudest on a cold start and disappears or quiets as the metal expands and reseals. TruckGuider's 6.4L guide separates this from lifter failure on exactly that warm-up test, and it is the far cheaper fix.

Likely causes

  1. Broken exhaust manifold bolts from heat cycling → Shop the exhaust manifold bolts at Amazon
  2. Warped exhaust manifold lifting off the gasket → Shop the exhaust manifold gasket at Amazon
  3. Failed exhaust manifold gasket at the rear cylinders → Shop the exhaust manifold at Amazon
  4. Loose heat shield rattling on cold starts

How to fix it — step by step

  1. Start it cold and listen at the rear of each bank; note whether the tick fades as the engine reaches operating temperature
  2. Check for any misfire code; a manifold leak normally sets none, while a lifter failure often sets one for a single cylinder
  3. With the engine cold, look for soot at the manifold flange and for missing or broken bolt heads
  4. Have the manifold checked for warping while it is off; replacing bolts alone on a warped manifold leaks again
  5. Leave flush-broken bolt extraction in the aluminum head to a shop with the right kit

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related RAM Truck 2500 (DJ, 2014–2026) problems

See all RAM 2500 (DJ, 2014–2026) codes & guides →