Porsche Coupe 911 Intake flap actuator failure
What this problem usually means
The variable intake system on the 991.1 uses plastic flap actuators that can fail. The failure causes a check engine light but no driveability issue, and the repair runs around $400.
Likely causes
- Failed plastic variable intake flap actuator → Shop the intake flap actuator at Amazon
How to fix it — step by step
- Scan for the fault code pointing to the intake flap system; the car typically drives normally
- Confirm the actuator, rather than the flap shaft itself, has failed before ordering parts
- Replace the failed plastic actuator
- Clear the code and verify the flap cycles correctly through a drive cycle
- No further action is needed if the light stays off and performance is unchanged
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the intake flap actuator.
Parts that commonly fix it
- intake flap actuator - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.