Porsche Coupe 911 Engine misfiring from ignition coil failure
What this problem usually means
On the 991 generation, ignition coil packs can fail intermittently, causing misfires. A flashing check engine light or poor performance, especially after driving through rain or a car wash, is a classic presentation on water-cooled 911s; a failed coil leads to misfires, poor acceleration and decreased fuel efficiency.
Likely causes
- Failed ignition coil pack
- Age and heat degradation of the coils
How to fix it — step by step
- Scan for misfire codes and note which cylinder is affected
- Swap the suspect coil with one from a good cylinder; if the misfire follows the coil, the coil is the fault
- Inspect the spark plug on the affected cylinder while the coil is off
- Do not keep driving with a flashing check engine light, which signals an active misfire that can damage the catalytic converters
- Replace the failed coil; on higher-mileage cars, replacing the full set with plugs is common practice
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the ignition coils.
Shop the ignition coils at Amazon
Also tied to this fault: spark plugs - Shop at Amazon
Parts that commonly fix it
- ignition coils - Shop at Amazon
- spark plugs - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.