Philips Air purifier AC2958 Filter replacement alert (red)

What this problem usually means

The filter replacement alert lights up red: the NanoProtect Series 3 filter (FY2180/30) is almost expired and must be replaced. If the alert has been on continuously and the filter is still not replaced, the appliance locks (healthy air protect lock) and stops operating.

Likely causes

  1. Filter lifetime nearly or fully expired
  2. Appliance locked because an expired filter was kept in use

How to fix it — step by step

  1. Remove the back cover and pull the old filter out of the appliance.
  2. Remove all packaging from the new NanoProtect Series 3 filter (FY2180/30) and install it as described in the manual's 'Installing the filter' section. → Shop the nanoprotect series 3 filter (fy2180/30) at Amazon
  3. Reattach the back cover and switch the appliance on.
  4. Touch and hold the filter status check/reset button for 3 seconds to reset the filter replacement time.
  5. Wash your hands after handling the filter.

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Philips Air purifier AC2958 problems

See all Philips AC2958 codes & guides →