Nissan Sedan Sentra Brakes not engaging
What this problem usually means
Brake problems recur on the Sentra, with many 2013 owners reporting the brakes do not engage until the pedal hits the floor, traced in some vehicles to a master brake cylinder that failed prematurely. Some 2020 units also have anti-lock braking systems that can stop working without warning, which can cause loss of control on slippery roads.
Likely causes
- prematurely failed master brake cylinder → Shop the brake master cylinder at Amazon
- abs failure on some 2020 units
How to fix it — step by step
- Stop driving if the pedal goes to the floor or stopping distance grows, and park safely
- Press the pedal with the engine off and note how far it travels
- Check whether the ABS warning light is on
- Have a shop replace the bad master cylinder and inspect the ABS before driving again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the brake master cylinder.
Parts that commonly fix it
- brake master cylinder - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Nissan manual is on Nissan's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.