Neato Robot vacuum Botvac D7 House Clean / Spot Clean LED - Blinking Red (Info LED Blinking Red on some models)

What this problem usually means

Your robot needs to be cleaned to operate at best performance (maintenance needed).

Likely causes

  1. Dirty / full filter or dirt bin
  2. Dirt bin not properly seated
  3. Hair / debris on the brush and end caps
  4. Wheel wells blocked with debris
  5. Dirty drop sensor windows

How to fix it — step by step

  1. Ensure the filter and dirt bin are clean and properly inserted; the top of the dirt bin should be level with the top of the robot → Shop the filter at Amazon
  2. Make sure the brush and end caps are clear of debris and remove hair wrapped around it
  3. Make sure wheel wells are not blocked with debris
  4. Spin the laser housing with a dry cotton swab 5 times in each direction, avoiding the openings
  5. Clean the two drop sensor windows on the bottom with a dry cotton swab
  6. Press and hold the Start Button for 10 seconds to reset, then press Start to turn it back on

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Neato Robot vacuum Botvac D7 problems

See all Neato Botvac D7 codes & guides →