Neato Robot vacuum Botvac D5 Batt_deep_discharge (message in the Neato app)
What this problem usually means
The battery is deeply discharged / reported dead. Reported in the app on D3 and D7 units on iFixit, and covered for the whole D3-D7 series in a third-party replacement-battery manual - this is NOT in the official Neato D5/D7 user guide, so treat it as a repair-source entry, not an official chart code.
Likely causes
- Battery fully drained to 0% / left discharged
- Aged / failed battery pack → Shop the battery pack at Amazon
- New replacement battery not yet stabilised over charge cycles
How to fix it — step by step
- Put the robot on the charge base and allow it to charge fully, even if charging appears to stop and restart; a new battery may need several cycles to stabilise
- Do not let the battery drain to 0% - recharge or shut the robot down at 5-10%
- If the error will not clear with a known-good battery, seek service from an independent vacuum repair shop (Neato shut down in 2023, so there is no manufacturer service) - do not attempt battery 'jumpstart' tricks described in some third-party guides
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Battery pack.
Parts that commonly fix it
- Battery pack - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.