Neato Robot vacuum Botvac D3 Error 3000
What this problem usually means
Error 3000 on a Botvac D3: the LDS turret spins at varying speeds and the scan comes back mostly as error 8080 - the laser is not producing a usable scan. Documented in a single investigation thread; the suggested endpoint was replacing the Lidar unit.
Likely causes
- An LDS turret spinning at the wrong speed (it should run at about 5Hz, PWM-controlled)
- A failing Lidar unit
How to fix it — step by step
- Connect NeatoControl and run GetLDSScan: mostly 8080 errors confirms the Lidar is at fault
- Check the LDS spin motor and its drive
- Replace the Lidar unit if the scan stays bad with a good motor drive → Shop the lidar (lds) unit at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Lidar (LDS) unit.
Parts that commonly fix it
- Lidar (LDS) unit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Neato Robot vacuum Botvac D3 problems
- House Clean / Spot Clean LED - Blinking Red (Info LED Blinking Red on some models)
- House Clean / Spot Clean LED - Solid Red (Info LED Solid Red on some models)
- Robot Offline (message in the Neato app)
- Wi-Fi LED - Fast Blinking Red
- batt_deep_discharge (message in the Neato app)
- Battery LED - Blinking Red