Mitsubishi SUV Outlander ABS, 4WD and stability warning lights together
What this problem usually means
Outlanders commonly light up ABS, 4WD and ASC (stability control) warnings at the same time, losing ABS and AWD and sometimes dropping into limp mode. Engine Patrol attributes most cases to a defective ABS wheel speed sensor.
Likely causes
- Failed ABS wheel speed sensor → Shop the abs wheel speed sensor at Amazon
- Damaged sensor wiring or reluctor ring
How to fix it — step by step
- Have codes read - the scan identifies which wheel's sensor is faulty
- Inspect that sensor and its harness for damage or corrosion
- Try cleaning the sensor first; replacement is a few hundred dollars if it is dead
- If the sensor is integral to the hub, the wheel hub assembly may need replacement instead
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the abs wheel speed sensor.
Parts that commonly fix it
- abs wheel speed sensor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.