Mercedes-Benz Sedan C-Class Oil leak from camshaft adjuster magnet

What this problem usually means

On the C-Class's M274 and M264 four-cylinder engines (C 300), the camshaft adjuster magnets - also called camshaft solenoids - sit on the front of the engine and control variable valve timing. Their internal seals harden with heat and engine oil seeps through the solenoid into its electrical connector; left alone, oil wicks along the wiring harness toward other connectors and, in the worst cases, a control unit. The fix is to replace the magnets, deal with the oily connector and check how far the oil has travelled.

Likely causes

  1. Camshaft adjuster magnet internal seal hardened with heat → Shop the camshaft adjuster magnet at Amazon
  2. Oil wicking through the wiring harness toward the ECU

How to fix it — step by step

  1. Unplug a camshaft magnet connector at the front of the engine and check for oil inside it
  2. Check for timing-related fault codes and a check engine light
  3. Replace the leaking magnet(s) and clean/repair the oily connector
  4. Inspect the harness and ECU connector; oil that has reached the control unit is the expensive version of this fault

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mercedes-Benz Sedan C-Class problems

See all Mercedes-Benz C-Class codes & guides →