Maytag Washer Top-Load (Tech Manual W11521160) F0 E4 Error Code

What the F0 E4 code means

Spin is limited by water temperature: the water is too high in temperature to spin at final speed, so speed is limited to 500 RPM.

Likely causes

  1. Hot and cold hoses reversed
  2. Cold water not reaching the washer for the final rinse
  3. Inlet water temperature sensor fault

How to fix it — step by step

  1. Check the hot hose is on the hot inlet and the cold hose is on the cold inlet
  2. Check the cold faucet is fully open
  3. Run a rinse and spin and check the code clears
  4. If it returns with the hoses correct, call for service for the inlet valve/sensor → Shop the water inlet valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F0 E4 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Maytag manual is on Maytag's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Maytag Washer Top-Load (Tech Manual W11521160) error codes

See all Maytag Top-Load (Tech Manual W11521160) codes & guides →