Levoit Air purifier Vital 200S Air Quality Indicator always stays red
What this problem usually means
The Air Quality Indicator always stays red, per the Vital 200S troubleshooting table. The manual also notes that if the indicator is red (Bad air quality) more than usual, the dust sensor may need cleaning.
Likely causes
- AirSight Infrared Dust Sensor lens needs cleaning
- Ultrasonic humidifier mist near the purifier - the dust sensor detects the large mist particles and the indicator turns red
How to fix it — step by step
- Clean the dust sensor lens: unplug the purifier, open the dust sensor cover, clean the lens with a cotton swab dipped in water, wipe it dry with a dry cotton swab, and replace the dust sensor cover (do not remove the foam piece on the cover unless Customer Support instructs it)
- Avoid using an ultrasonic humidifier near the air purifier, or avoid using Auto Mode while one is running nearby
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.