Land Rover SUV Range Rover Check Engine Light On
What this problem usually means
On the Range Rover the engine management light most often traces back to timing trouble on the diesels or misfires on the 5.0-litre petrol V8. AutoFixFair describes the 4.4-litre TDV8's rear-mounted secondary timing chain stretching prematurely, giving a cold-start rattle, misfires and the engine management light, with the 3.0-litre TDV6 suffering timing chain wear at high mileage. Separately, Land Rover technical bulletin LTB00409NAS3 covers the 5.0 V8 (naturally aspirated and supercharged, L322 and L405) for a misfire, poor fuel economy, hard starting and a rough idle with the MIL illuminated and misfire codes P0301 through P0308 plus P0316 stored, caused by clogged fuel injectors from poor fuel quality or contamination. A flashing light means an active misfire: stop driving it, because unburned fuel overheats the catalytic converters.
Likely causes
- Stretched secondary timing chain on the 4.4 TDV8 diesel, with worn tensioners or guides
- Timing chain wear on high-mileage 3.0 TDV6 diesel examples
- Clogged fuel injectors from poor fuel quality or fuel contamination on the 5.0 V8 petrol (bulletin LTB00409NAS3) → Shop the fuel injectors at Amazon
- Extended oil intervals accelerating chain and tensioner wear on the diesel engines
How to fix it — step by step
- Note whether the light is solid or flashing, and stop driving on a flashing light, which means a live misfire
- Read the exact codes with an OBD-II scanner and write them down: timing correlation codes point at the chain, P0301-P0308 misfire codes at a cylinder or injector → Shop the timing chain kit at Amazon → Shop the obd-ii scanner at Amazon
- Do a cold-start listening test: a TDV8 chain rattle is a start-up noise that should clear quickly, and any persistent rattle needs immediate specialist inspection
- Check the oil level and service history; overdue oil changes make diesel chain wear worse, not better
- On a 5.0 V8 petrol with P0316 plus one or more of P0301-P0308 and no other codes, suspect clogged injectors per bulletin LTB00409NAS3 before condemning ignition parts
- Have a Land Rover specialist confirm chain stretch or injector flow before authorising parts, then clear the codes and confirm the light stays off through a full drive cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the OBD-II scanner.
Shop the OBD-II scanner at Amazon
Also tied to this fault: fuel injectors - Shop at Amazon; timing chain kit - Shop at Amazon
Parts that commonly fix it
- OBD-II scanner - Shop at Amazon
- fuel injectors - Shop at Amazon
- timing chain kit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.