Land Rover SUV Range Rover Sport Check Engine Light On
What this problem usually means
The Range Rover Sport's check engine light follows the two engine families it shares with the full-size car. Land Rover technical bulletin LTB00409NAS3 names the Sport (2010-2013) with the 5.0-litre V8 petrol: a misfire, poor fuel economy, hard starting and a rough idle with the MIL illuminated and misfire codes P0301 through P0308 plus P0316 stored, caused by clogged fuel injectors from poor fuel quality or fuel contamination. On the diesel side, LRDirect lists the Sport (L405) among the models fitted with the 2.0-litre Ingenium diesel whose timing chains stretch — typically around 60,000 to 80,000 miles, and worst on pre-2019 cars — bringing the check engine light on with camshaft/crankshaft correlation codes P0016 or P0341, misfires and power loss, accelerated by oil dilution from incomplete DPF regenerations.
Likely causes
- Clogged fuel injectors from poor fuel quality or fuel contamination on the 5.0 V8 petrol (bulletin LTB00409NAS3)
- Stretched timing chain on the 2.0 Ingenium diesel, especially pre-2019 cars
- Oil dilution from incomplete DPF regenerations thinning the oil and accelerating chain, guide and tensioner wear
- Worn plastic timing chain guides shedding debris into the oil system on the Ingenium diesel
How to fix it — step by step
- Note whether the light is solid or flashing, and stop driving on a flashing light, which means a live misfire
- Read the exact codes with an OBD-II scanner and sort them by family: P0301-P0308 plus P0316 with no other codes points at injectors on the V8 petrol, while P0016 or P0341 points at timing chain stretch on the Ingenium diesel → Shop the timing chain kit at Amazon → Shop the obd-ii scanner at Amazon
- Listen for a metallic rattle from the rear of the engine on a cold start, the classic early sign of Ingenium chain stretch
- On a diesel, check the oil level and smell the oil: a level above maximum or a fuel smell indicates DPF-regeneration oil dilution
- Replace the fuel injectors indicated by the misfire codes only after other misfire causes are ruled out, as the bulletin directs → Shop the fuel injectors at Amazon
- Have a Land Rover specialist confirm chain stretch before authorising a timing chain kit, then clear the codes and confirm the light stays off through a full drive cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the OBD-II scanner.
Shop the OBD-II scanner at Amazon
Also tied to this fault: fuel injectors - Shop at Amazon; timing chain kit - Shop at Amazon
Parts that commonly fix it
- OBD-II scanner - Shop at Amazon
- fuel injectors - Shop at Amazon
- timing chain kit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.