Land Rover SUV Evoque Check Engine Light On

What this problem usually means

The Evoque's engine management light is most often a diesel emissions or timing story, with one documented petrol cause. K Motors, a Land Rover specialist, lists the 2.0 Ingenium diesel's timing chain failure — rooted in oil dilution from incomplete DPF regenerations — turbocharger failure showing as a loss of power with the engine management light, a carbon-blocked EGR valve giving excessive smoke, power loss and the light, and DPF blockage on urban, short-trip use that ends in the 'Exhaust Filter Full' message. On the 2.0 GTDi petrol (2012-2014), Land Rover technical bulletin LTB00730NAS1 documents the MIL illuminating with fuel-pressure codes P00C6, P228D or P228C plus misfire codes P0300-P0304 and P1315, rough running, hard starting and restricted performance, caused by an internal fault with the metering valve in the high-pressure fuel pump.

Likely causes

  1. Timing chain stretch on the 2.0 Ingenium diesel, driven by oil dilution from incomplete DPF regenerations → Shop the timing chain kit at Amazon
  2. Turbocharger failure on the 2.0 Ingenium diesel, with power loss and the engine management light → Shop the turbocharger at Amazon
  3. Carbon build-up stopping the EGR valve opening and closing properly on diesel models → Shop the egr valve at Amazon
  4. DPF blockage from short urban trips and interrupted regenerations on diesel models
  5. Internal metering-valve fault in the high-pressure fuel pump on the 2.0 GTDi petrol (bulletin LTB00730NAS1)

How to fix it — step by step

  1. Note whether the light is solid or flashing, and stop driving on a flashing light, which means a live misfire
  2. Read the exact codes with an OBD-II scanner and write them down: P0016-type correlation codes point at the chain, boost codes at the turbo, P00C6/P228D/P228C at the petrol's high-pressure fuel pump → Shop the high pressure fuel pump at Amazon → Shop the obd-ii scanner at Amazon
  3. Listen on a cold start for chain rattle, and when driving for a siren-like turbo whistle or whine that gets progressively worse, with blue smoke under acceleration
  4. If the car shows the DPF 'Exhaust Filter Full' message, follow the handbook's regeneration drive promptly instead of continuing short trips
  5. On a petrol car that cuts out from cold, will not rev past about 4,000 rpm at a standstill or misfires under full throttle, suspect the high-pressure fuel pump metering valve per bulletin LTB00730NAS1
  6. Have a Land Rover specialist confirm the failed component before authorising a chain kit, turbo or pump, then clear the codes and confirm the light stays off through a full drive cycle

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Land Rover SUV Evoque problems

See all Land Rover Evoque codes & guides →