Kia SUV Sorento Check Engine Light On
What this problem usually means
The most serious check engine light pattern on the Theta II Sorento is a flashing malfunction indicator lamp, not a steady one. Kia's product improvement campaign PI1802 installs Knock Sensor Detection System (KSDS) software that detects vibrations indicating the onset of excessive connecting rod bearing wear; when it triggers, DTC P1326 is recorded, the lamp blinks continuously and the vehicle is placed in Limp Home Mode, accelerating slowly with engine speed limited to roughly 1,800-2,000 RPM. Kia designed the system to warn the driver early, before severe engine damage or failure, so a flashing lamp with P1326 on a 2014-2018 Sorento with the 2.4L or 2.0T GDI engine is a stop-and-check warning, not a drive-on fault.
Likely causes
- Excessive connecting rod bearing wear, detected as abnormal vibration by the knock sensor (DTC P1326) → Shop the knock sensor at Amazon
- Bearing damage progressing toward severe engine damage or engine failure if the warning is ignored
- KSDS ECU software not yet installed under Kia campaign PI1802, so the bearing-wear detection is not active on the vehicle
How to fix it — step by step
- If the malfunction indicator lamp is flashing and the vehicle feels limited to low speed (Limp Home Mode), drive as little as possible and have the code read immediately; P1326 is specific to the KSDS
- Check the engine oil level and listen for engine knocking; do not keep driving a knocking engine
- Have a Kia dealer check by VIN whether the PI1802 KSDS ECU update has been installed and whether the vehicle is covered by the campaign
- The dealer performs the bearing clearance inspection Kia specifies for P1326; Kia's follow-on bulletin PI1803 sets out the engine replacement procedure when the inspection fails - this is not a DIY repair
- After any repair, clear the code and confirm the lamp stays off and Limp Home Mode does not return
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the knock sensor.
Shop the knock sensor at Amazon
Also tied to this fault: connecting rod bearings - Shop at Amazon; short block assembly - Shop at Amazon
Parts that commonly fix it
- knock sensor - Shop at Amazon
- connecting rod bearings - Shop at Amazon
- short block assembly - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.