Jeep SUV Compass Tie rod and control arm failure

What this problem usually means

Compass suspension problems centre on tie rod and control arm/bushing failure: tie rod failure is one of the most common problems with the 2008 Compass, showing up as unusual sounds and odd tire wear, and control arm/bushing failure is the most common 2007 Compass problem on CarComplaints.com with 17 reports at around 58,000 miles. One owner reported the vehicle skewing to the passenger side in a turn and hitting the sidewalk, so worn parts are a steering safety issue.

Likely causes

  1. worn or failed tie rod ends
  2. failed control arm bushings
  3. worn ball joints and control arms

How to fix it — step by step

  1. Stop driving if the steering pulls, wanders or clunks in turns, and park safely
  2. Inspect tire wear patterns and check tie rod ends, control arms and bushings for play on a lift → Shop the control arm bushings at Amazon → Shop the tie rod ends at Amazon
  3. Note any clunking over bumps or noise when turning a corner
  4. Replace the worn tie rod ends, control arms, bushings or ball joints found → Shop the control arms at Amazon → Shop the ball joints at Amazon
  5. Get a wheel alignment after the repair and confirm the steering tracks straight

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Jeep SUV Compass problems

See all Jeep Compass codes & guides →