Jeep SUV Compass Brakes grinding noise
What this problem usually means
Owners of 2012 and 2014 Compasses have complained about noisy, grinding brakes, a low-pitched noise noticeable from early in the vehicle's life, at around 8,950 miles for 2012 models and 12,700 miles on average for 2014 models. FCA released TSB 05-003-16 in August 2016 suggesting an anti-vibration bracket be installed on the rear brake caliper to get rid of the noise.
Likely causes
- rear brake caliper vibration causing a low grinding noise when braking
- brake component noise that persisted for some owners even after replacing brakes
How to fix it — step by step
- Stop driving if braking feels weak or the pedal changes, and park safely
- Note whether the grinding comes from the rear and happens on most stops
- Inspect pads and rotors for wear or scoring before assuming it is only vibration noise
- Ask a dealer or shop to check TSB 05-003-16 and install the anti-vibration bracket on the rear brake caliper → Shop the anti-vibration bracket at Amazon → Shop the rear brake caliper at Amazon
- Replace any worn pads or rotors found, then road-test and confirm the noise is gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the anti-vibration bracket.
Shop the anti-vibration bracket at Amazon
Also tied to this fault: rear brake caliper - Shop at Amazon
Parts that commonly fix it
- anti-vibration bracket - Shop at Amazon
- rear brake caliper - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.