Jeep SUV Cherokee Power transfer unit failure
What this problem usually means
On 2014-2022 Cherokees the power transfer unit (PTU), the part of the AWD system attached to the transmission, is a known trouble area with many failure complaints on the NHTSA website. FCA issued Safety Recalls W47 and W48 for the PTU, and replacing it outside a recall or warranty is costly, so the 4WD system needs thorough testing on any used Cherokee.
Likely causes
- failing power transfer unit in the awd system
- ptu defects covered by fca safety recalls w47 and w48
How to fix it — step by step
- Stop driving in 4WD modes if the PTU grinds, binds or loses drive, to avoid further driveline damage
- Check by VIN whether the recall applies, specifically the W47 and W48 PTU recalls named in the source
- Test every 4WD mode on a safe surface and note noises, binding or warning messages
- Have a shop inspect the PTU and the rear driveline module for the source of the fault
- Replace the failed power transfer unit if testing confirms it, and re-test all 4WD modes → Shop the power transfer unit at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the power transfer unit.
Parts that commonly fix it
- power transfer unit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.