iRobot Floor scrubber Scooba 5900 Stops putting down solution mid-clean
What this problem usually means
Scooba starts out laying solution, then stops part-way through the run even though the clean tank still has solution.
Likely causes
- Broken struts on the tank inlet lance so the valve closes as the run goes on
- The tank is not fully clamped down, breaking the seal (test by clamping it with tape)
- The pump cam/roller mechanism jammed by a loose part
- A pump motor that runs at start-up checks but stalls under load
How to fix it — step by step
- Inspect the inlet lance struts for cracks or breaks
- Run a test with the tank firmly clamped (tape test) to check the tank seal
- Run the built-in self-tests to isolate the pump motor
- Open the pump area and check the cam/roller mechanism for a loose or jammed part
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Solution pump.
Parts that commonly fix it
- Solution pump - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.