iRobot Floor scrubber Scooba 5900 Not putting down solution
What this problem usually means
Scooba runs but lays down little or no cleaning solution. The checks below are the standard procedure for the original Scooba generation.
Likely causes
- The pump is not running or is air-locked
- A leg of the three-legged inlet lance inside the tank opening is broken, so it cannot open the tank's outlet valve
- The clean tank outlet valve or vent valve is stuck
- A clogged tank filter screen
How to fix it — step by step
- Listen just after pressing Clean: the pump motor should run for about 3 seconds
- Remove the tank and inspect the inlet lance - all three legs must be intact to open the tank valve
- Purge the solution path: use a bulb syringe to push water through the lance down to the floor jets
- Check the clean tank outlet valve flows freely and the vent valve opens; clean the tank filter screen
- If the pump never runs, test it via the self-tests and replace the pump if it has failed
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Solution pump.
Parts that commonly fix it
- Solution pump - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.